Water Switch System ID & IID

Sinicon waterswitch system (id, iid, idt, iidt); consists 1 no. Controller and 1 no. Waterswitch for system id/idt configuration and 1 no. Controller and 2 nos. Waterswitch for system iid/iidt configuration, effectively monitor and controls water/liquid levels in the overhead tank, sump, well etc. It prevents overhead tank from overflowing and also over pumping of sump, well etc. Thanks to sinicon waterswitch system, the user need not worry about switching the electric water pump on and off and it makes water available round the clock.

The controller (model 9526b) in the waterswitch system prevents pump from running when the sump is empty, or during low voltage, high voltage and dry run situation, thus avoiding damage to motor resulting in increased profitability, cost saving in electricity and maintenance.

Functions & Features

• Fully automatic or manual operation.
• Switches water pump on when overhead tank is empty and switches water pump off when overhead tank is full.
• Switches water pump off when sump/well is empty (even while the overhead tank is empty) and allow pump to run only when the sump/well is filled up to the set limit.
• Extremely easy to install and operate.
• Fit and forget type and no routine maintenance required.
• Single switch operation for auto/off-reset/manual operations.
• Low/high voltage protection and dry run protection to motor.

Special Features on Request

• Other voltage and frequency
• Operation conditions
• Higher capacity